These high quality, economical inspection mirrors are available in various sizes and are used to inspect difficult access areas. Handles vary in length and extend up to 11″ (Model S-2). A “must have” for the coatings inspector. Model E2TM is equipped with a magnet on the opposite end from the mirror for retrieving small out-of-reach magnetic items.
K-2
$8.50
These high quality, economical inspection mirrors are available in various sizes and are used to inspect difficult access areas.
In stock
Related products
C-2
These high quality, economical inspection mirrors are available in various sizes and are used to inspect difficult access areas.
Cross Cut Knife
The KTA Cross Cut Guide Kit contains all of the equipment you will need to perform cross-cut adhesion testing according to Method B in ASTM D3359, "Measuring Adhesion By Tape Test."
M1 (Battery Operated) 67.5v
Verify a pinhole-free coating using the Tinker-Rasor low voltage wet sponge holiday detector.
KTA Cross-cut Guide CCG-2MM KIT
The KTA Cross Cut Guide Kit contains all of the equipment you will need to perform cross-cut adhesion testing according to Method B in ASTM D3359, "Measuring Adhesion By Tape Test."
All goods are in stock!!
Vaprecision Calcium Chloride Vapor Emission Test Kit
The Vaprecision Calcium Chloride Moisture Vapor Emission Kit contains all of the supplies to check for residual moisture in concrete slabs.
Positest Air Leak Tester Solution
A replacement case of 16 bottles of the PosiTest Air Leak Tester solution.
S-2
These high quality, economical inspection mirrors are available in various sizes and are used to inspect difficult access areas.
Corporate Worker Safety and Health Program for Construction Painting Projects
Developed under the direction of a Certified Industrial Hygienist, the KTA Corporate Worker Safety and Health Program for Industrial Painting Projects is designed to provide guidance on the safety and health hazards typically encountered on industrial maintenance painting projects. This program is specifically designed for use on projects where the OSHA Construction Industry standards (29 CFR 1926) are applicable.
