Testex replica tape is used in conjunction with an analog or digital spring-loaded micrometer for acquiring surface profile measurements according to Method C in ASTM D4417. The replica tape is rubbed onto the abrasive blast cleaned surface forming a reverse replica of the peak-valley pattern in the steel. The replica is quantified using a spring loaded micrometer to determine the maximum peak-to-valley depth. Each roll of tape contains 50 pieces.
X-Coarse 1.5 to 4.5 mils (38 to 115 microns)
$36.00
Testex replica tape is used in conjunction with an analog or digital spring-loaded micrometer for acquiring surface profile measurements according to Method C in ASTM D4417.
In stock
Related products
Fine Blade PA2052 1mm spacing – 6 teeth (Blade Only)
PA2000 1mm 6 Teeth Cutting Blade Designed for use with the PA2000 Adhesion Test Kit blade handle this blade will
Positest Air Leak Tester Solution
A replacement case of 16 bottles of the PosiTest Air Leak Tester solution.
Surface Coatings for protection against wear
This book covers coating characterization and property evaluation relevant to wear resistance with an emphasis on mechanical testing of coatings and discusses the various methods used to deposit wear resistance coatings.
Cross Hatch Tape
M.E. Taylor Cross Hatch Tape Designed with ASTM D3359-09e2 in mind the M.E. Taylor cross hatch tape is perfect for
S-2
These high quality, economical inspection mirrors are available in various sizes and are used to inspect difficult access areas.
Replacement Cross Cut Knife Blades
Replacement Cross Cut Knife Blades Designed for use with the Stanley utility knife that is included in the KTA Cross
M1 (Battery Operated) 67.5v
Verify a pinhole-free coating using the Tinker-Rasor low voltage wet sponge holiday detector.
Corporate Worker Safety and Health Program for Construction Painting Projects
Developed under the direction of a Certified Industrial Hygienist, the KTA Corporate Worker Safety and Health Program for Industrial Painting Projects is designed to provide guidance on the safety and health hazards typically encountered on industrial maintenance painting projects. This program is specifically designed for use on projects where the OSHA Construction Industry standards (29 CFR 1926) are applicable.
