Verify a pinhole-free coating using the Tinker-Rasor low voltage wet sponge holiday detector. Tinker-Rasor is a leader in holiday detection equipment. The portable, plastic solid state transitorized nondestructive low voltage (67.5v) detector uses regular potable water from a wetted sponge and a ground wire (attached to the uncoated substrate) to complete a circuit and produce an audible signal indicating a pinhole or flaw in the coating. A red indicator light also illuminates when the detector alarms. The tester is suitable for use on any nonconductive coating (up to 20 mils thick) applied to a conductive substrate. While there is no spark hazard during detection, the device operates on batteries and is not intrinsically safe. Model M1/AC employs 110/120v AC and operates on the same principle as the M1, but can be adjusted for various sensitivities to detect moisture permeable areas in coatings. The detector is sold complete with batteries, bottle of non-sudsing wetting agent for use when inspecting coatings in the 10-20 mil range, 15 foot ground wire, 18″ phenolic wand with lead and sponge. The wetting agent should not be used when testing between coats. The detector conforms to ASTM D5162. Made in the USA.
M1 (Battery Operated) 67.5v
$395.00
Verify a pinhole-free coating using the Tinker-Rasor low voltage wet sponge holiday detector.
In stock
SKU: 213318
Category: Uncategorized
Related products
K-2
$8.50
These high quality, economical inspection mirrors are available in various sizes and are used to inspect difficult access areas.
C-2
$8.45
These high quality, economical inspection mirrors are available in various sizes and are used to inspect difficult access areas.
Cross Cut Knife
$7.00
The KTA Cross Cut Guide Kit contains all of the equipment you will need to perform cross-cut adhesion testing according to Method B in ASTM D3359, "Measuring Adhesion By Tape Test."
Surface Coatings for protection against wear
$270.00
This book covers coating characterization and property evaluation relevant to wear resistance with an emphasis on mechanical testing of coatings and discusses the various methods used to deposit wear resistance coatings.
Positest Air Leak Tester Solution
$95.00
A replacement case of 16 bottles of the PosiTest Air Leak Tester solution.
Rilem Tube
$28.50
Vertical Rilem Tubes are used to measure the rate at which water moves through porous materials like masonry.
Spy 670 Low Voltage Pinhole Detector
$440.00
Verify a pinhole-free coating using the Spy low voltage wet sponge holiday detector.