PosiTest AT Hole Saw 20MM
$25.00
Hole saws for adhesion testing isolate test areas by cutting coatings or substrates. Compatible with ASTM C1583; available in 14, 20, and 50 mm sizes.
Hole Saw for Adhesion Testing
- Precise Test Area Isolation – Ideal for cutting or scoring through coatings or substrates to define a specific diameter test area.
- Recommended Use – A 14 mm, 20 mm, or 50 mm hole saw can be used to cut around the dolly (pull stub) to isolate the test area and remove excess adhesive.
- Strong Lateral Bonding Consideration – For coatings with high lateral adhesion, it is advised to cut completely through the coating down to the substrate.
- Concrete Repair & Overlay Testing (ASTM C1583) – Use a 50 mm diamond-impregnated hole saw to create a perpendicular cut at least 10 mm (0.5 inches) deep.
- Included Accessories – Depending on the model, a hole saw is included with each PosiTest Adhesion Tester or Conversion Kit (except ATA50T and AT50TKIT). A 14 mm hole saw is available for use with 14 mm dollies.
Only logged in customers who have purchased this product may leave a review.
Related products
Testex Press-O-Film Replica Tape – Legacy Roll
Testex replica tape is used in conjunction with an analog or digital spring-loaded micrometer for acquiring surface profile measurements according to Method C in ASTM D4417. The replica tape is rubbed onto the abrasive blast cleaned surface forming a reverse replica of the peak-valley pattern in the steel. The replica is quantified using a spring-loaded micrometer to determine the maximum peak-to-valley depth. Each roll of tape contains 50 pieces.
Coarse 0.8 to 2.5 / 20 to 64
X-Coarse 1.5 to 4.5 / 38 to 115
X-Coarse Plus 4.6 to 5.0 / 116 to 127
If you are looking for the new Testex cartons, click here.
Reviews
There are no reviews yet.