PosiTest AT Hole Saw 10MM
$15.00
Precision hole saws for adhesion testing, designed to isolate test areas by cutting through coatings or substrates. Available in 14, 20, and 50 mm sizes.
Ships today
Description
Hole Saw for Adhesion Testing
- Precise Test Area Isolation – Ideal for cutting or scoring through coatings or substrates to define a specific diameter test area.
- Recommended Use – A 14 mm, 20 mm, or 50 mm hole saw can be used to cut around the dolly (pull stub) to isolate the test area and remove excess adhesive.
- Strong Lateral Bonding Consideration – For coatings with high lateral adhesion, it is advised to cut completely through the coating down to the substrate.
- Concrete Repair & Overlay Testing (ASTM C1583) – Use a 50 mm diamond-impregnated hole saw to create a perpendicular cut at least 10 mm (0.5 inches) deep.
- Included Accessories – Depending on the model, a hole saw is included with each PosiTest Adhesion Tester or Conversion Kit (except ATA50T and AT50TKIT). A 14 mm hole saw is available for use with 14 mm dollies.
Additional information
| Weight | 1 lbs |
|---|
Reviews (0)
Only logged in customers who have purchased this product may leave a review.
Related products
PosiTector 200 Ultrasonic Coating Thickness Gauge
The PosiTector 200 Ultrasonic Coating Thickness Gauge measures the thickness of coatings over concrete, wood, composite materials, and more.
B-Probe for coatings over wood, composites. 0-40 mils.
C-Probe for coatings over concrete, fiberglass. 2-150 mils.
D-Probe for Thick soft coatings, polyureas, thick polymers. 2-300 mils.
Testex Press-O-Film Replica Tape - Legacy Roll
Testex replica tape is used in conjunction with an analog or digital spring-loaded micrometer for acquiring surface profile measurements according to Method C in ASTM D4417. The replica tape is rubbed onto the abrasive blast cleaned surface forming a reverse replica of the peak-valley pattern in the steel. The replica is quantified using a spring-loaded micrometer to determine the maximum peak-to-valley depth. Each roll of tape contains 50 pieces.
Coarse 0.8 to 2.5 / 20 to 64
X-Coarse 1.5 to 4.5 / 38 to 115
X-Coarse Plus 4.6 to 5.0 / 116 to 127
If you are looking for the new Testex cartons, click here.
DeFelsko Certified Coating Thickness Standards
Certified coated metal plates are ideal for verifying the accuracy and operation of coating thickness gauges and are an important component in fulfilling both ISO and in-house quality control requirements.
Many organizations require verification of gauge accuracy at the test site each time a coating thickness gauge is put into service and at frequent intervals during use. Ideal for this purpose, DeFelsko certified coating thickness standards have measured values traceable to a National Metrology Institution. FERROUS
S1 0, 3, 10, 60 mils
S2 0, 3, 10, 40 mils
Reviews
There are no reviews yet.