The Vaprecision Calcium Chloride Moisture Vapor Emission Kit contains all of the supplies to check for residual moisture in concrete slabs. Each kit contains three pre-labeled, sealed anhydrous calcium chloride canisters individually stored inside foil packets, three pre-gasketed clear plastic domes with Caution tags, a tack cloth to remove concrete surface dust, a concrete pH test, instructions for placement and a worksheet for calculating vapor emission rates according to ASTM F1869. Pre- and post-weighing of the canisters is required. Weighing services are provided by the KTA Laboratory (fee applies). An optional Vaprecision gram scale can also be purchased. Made in the USA.
Vaprecision Calcium Chloride Vapor Emission Test Kit
$39.00
The Vaprecision Calcium Chloride Moisture Vapor Emission Kit contains all of the supplies to check for residual moisture in concrete slabs.
In stock
Related products
DE Stearns 14/20 High Voltage Holiday/Pinhole Detector
Verify a pinhole-free coating using the DE Stearns high voltage holiday detector.
Replacement Flat Sponge
Replacement flat sponge for the Spy 670.
C-2
These high quality, economical inspection mirrors are available in various sizes and are used to inspect difficult access areas.
Fine Blade PA2052 1mm spacing – 6 teeth (Blade Only)
PA2000 1mm 6 Teeth Cutting Blade Designed for use with the PA2000 Adhesion Test Kit blade handle this blade will
Rilem Putty
The Rilem Putty is used to attach the Rilem Tube to vertical surfaces.
Surface Coatings for protection against wear
This book covers coating characterization and property evaluation relevant to wear resistance with an emphasis on mechanical testing of coatings and discusses the various methods used to deposit wear resistance coatings.
Replacement Cross Cut Knife Blades
Replacement Cross Cut Knife Blades Designed for use with the Stanley utility knife that is included in the KTA Cross
Fine Blade PA2053 1mm spacing – 11 teeth (Blade Only)
The Gardco Paint Adhesion Test Kit contains all of the equipment you will need to perform cross-cut adhesion testing according to Method B in ASTM D3359, "Measuring Adhesion By Tape Test."
